Rear Sensors

Rear sensors by Leather FX Australia’s Best Parking Systems

How do our reversing sensor systems work?

Parking Sensors are an accurate ultrasonic device which monitors the distance from your vehicle to potential obstacles in your blind spot. This distance is indicated by a sequence of beeps through a Piezo beeper (in some cases also by an optional digital display). The closer the obstacle the faster the sequence of beeps, until a continuous tone is emitted indicating that your vehicle is now within 30cm of an obstacle.
Ultrasonic Reverse Parking Sensor Systems electronically scan the area behind your vehicle during reversing procedures and acoustically alarms you to other vehicles or objects within close proximity.

BENEFITS
Reverse with increased safety and confidence. Faster and easier parking, especially in tight situations. Easier to park in wet conditions or dim lit areas at night. Helps prevent accident damage when parking. Provides side protection for narrow lanes or garages.

COVERAGE PATTERN

Our reversing sensor systems have NO blind spots!

rear parking sensor detection zones

ALERT ZONES

LeatherFX rear sensors systems have 4 zones and have different  tones for each of them.  This makes the system very user friendly.

rear parking sensors

DOES YOUR VEHICLE HAVE A TOW BAR?

EXTENDED ZONE
For vehicles fitted with a tow bar, our reversing sensor control module feature an adjustable extended zone which allows the system to ‘see’ past the obstruction by pushing the start of the first zone out by 30cm. Refer Diagrams below.

FLAT BUMPER SENSOR

reversing sensor

Most commonly used sensor head – required to be at least 450 mm above ground level on a vertical surface. This sensor head can be painted to match your vehicles colour.

10 DEGREE SENSOR

reversing sensors

Used on curved surfaces and can be installed 10 degree up or down to straighten out the line of sight for the ultrasonic signal. This sensor head can be painted to match your vehicles colour.

FLAT RUBBER SENSOR

reversing sensors

Used on metal bars to avoid interference. Extremely durable to harsh weather conditions. NOT paintable

10 DEGREE RUBBER SENSOR

reversing sensors

Used on curved surfaces and can be installed 10 degree up or down to straighten out the line of sight for the ultrasonic signal. Used on metal bars to avoid interference. NOT paintable.

Get in touch

LeatherFX Contact 0410 753 130